A single cable provides 120-volt and 240V service. Every article I’ve seen describing the wiring of a shop for both 120 volts and 240V uses separate cables for each voltage, which is a [...]
Blacksmithing is a hasty sport. Unlike woodworking, where you can step back and contemplate a cabinet’s lines or run your hands over a planed surface to check its smoothness, working with hot [...]
A chairmaker explains his fascination with the ancient art of blacksmithing and being able to make his own woodworking tools. It was April of 1986, and I’d just arrived at a craft show up a long [...]
Hold and guide your work like never before with this fixture that will (finally) fix your drill press. There probably isn’t any machine more ignored in my shop than my drill press. Even [...]
Contradictory finishing information is frustrating. Here we clear up one example. By Bob Flexner Pages: 110-111 From the October 2005 issue #150 Buy this issue now Each month Popular Woodworking [...]
What we like (and dislike) about this revolutionary machine. By the Popular Woodworking staff Pages: 86-87 From the October 2005 issue #150 Buy this issue now A safe table saw – that’s the holy [...]
By David Thiel Pages: 53-60 From the October 2005 issue #150 Buy this issue now To open our seven-part series on casework construction it’s probably smart to include the definition of casework. [...]
By Robert W. Lang Page: 34 From the October 2005 issue #150 Buy this issue now A high price tag brings high expectations and the JessEm Mite-R-Excel lives up to its price. Thoughtfully [...]
By Christopher Schwarz Page: 33 From the October 2005 issue #150 Buy this issue now Though I own a powered jointer and planer, I always keep a scrub plane close by. It’s good for dressing boards [...]
By David Thiel Page: 33 From the October 2005 issue #150 Buy this issue now In our February 2005 issue we tested 15″ planers and, honestly, we missed one. The Shop Fox W1724 should have [...]
By Christopher Schwarz Page: 32 From the October 2005 issue #150 Buy this issue now Allow me to skip to the bottom line here and say that the Veritas Mk.II Honing Guide is the most thoughtful, [...]
By David Thiel Page: 32 From the October 2005 issue #150 Buy this issue now When Jet announced its new line of parallel jaw clamps, I asked if they would be less expensive. Company officials [...]
