The blade of a marking gauge must be as sharp as a scalpel in order to cut a fine line across the grain. Sharpening it can be very difficult because it’s so small. I solved that problem by making a gauge that accepts snap-off utility knife blades. I use epoxy to glue the blade into…

Accurately drilling an angled hole with a hand drill is a challenge – particularly if you’re using a brad point or Forstner bit. This angled drilling guide solves the problem handily. The guide keeps the drill bit from wandering as it enters the stock. It can be cut at any angle, and its alignment marks…

When using my miter saw, I’ve found that the easiest way to sneak up on a line is to use a stack of sticky notes. First, set a stop block to cut your part slightly oversize (1/16″ is plenty). Attach a thin pile of sticky notes to the stop block, make a cut, and then…

After brushing the first coat of finish on my shelf project, quite a bit remained in the disposable cup. I didn’t want to pour it back, because that would contaminate the fresh finish that remained in the can. But I didn’t want to waste the finish by throwing it away, either. Knowing the shelves were…

Gambler’s Micro-Adjust Precise fence adjustments are a sure bet when I clamp this shop-made device on my router table. I simply drilled and tapped a hole to accept a 1/4″-20 machine screw through the center of a 3/4-in. by 1-in. by 3-in. piece of hardwood. I covered the tip that contacts the fence with a…

While turning wooden pens, students in my woodshop classes kept wearing out the points on the live centers of our mini lathes. The points fit into the hollowed end of the pen mandrel. If the mandrel isn’t clamped tight enough between the lathe’s head and tailstock, it spins on the point and wears it out….

Small logs from a local downed tree are a great windfall of free lumber for small projects. They’re easy to saw into boards on the band saw once you have established a couple flat reference surfaces for safe feeding. I use a simple L-shaped carrier jig screwed together from scrap plywood to make the initial…

I like to buy used electric motors for powering various tools around the shop. I also use them to mount grinding wheels, wire brushes and buffing wheels. I typically outfit the motors with toggle switches because they’re light and small. However, as unobtrusive as they are, I would occasionally catch my sleeve on a switch,…

I always sign my work, now that I’ve figured out an easy and permanent way to do it: I use an engraver. But not just any engraver—it has to have an adjustable stroke (the distance the tip moves in and out). Set the stroke to maximum. An engraver works just like a pencil, but some…

Filling knots with colored epoxy usually works quite well, but sometimes the void is in a spot that’s difficult to fill, like the edge of a board. Here’s how to do it. First, apply some paste wax to a piece of melamine so the epoxy won’t adhere to it. Clamp the melamine to the workpiece,…

Before the advent of magnetic-based LED lights, many of us used flexible gooseneck lamps with an incandescent bulb as auxiliary lights on our drill presses and band saws. These lamps were usually screwed or clamped onto the machine. I acquired a Craftsman lamp many years ago, but there were many other brands and styles available….

Mice used to rule my shop. They got into everything! That all changed when someone told me that fresh mint repels mice. Mint grows wild in one corner of my yard (it’s a perennial and comes back each year), so every couple weeks, I pick a handful and spread it around my floor. Now my…