Search Results

While I was gluing up the pedestals for an oak desk, I realized I needed a way to hold the sides parallel at the front. Three Quick-Grip clamps and a scrap wood spacer did the trick. They [...]

The strong adhesive and tough plastic of packaging tape allow it to work as a hinge on long, mitered corners. After carefully cutting the miters, lay the boards outside-face up and side by side [...]

This small rack rolls easily to anywhere you need it. There is an old saying in woodworking that you can’t have too many clamps. While this is true, it is entirely possible to have too many [...]

An F-style clamp works well for getting into tight spaces, but how do you turn the handle? The answer: Just drill a couple of holes through it and insert a screwdriver. A 90° offset to the holes [...]

Make your own light-duty one-handed workholding wonders. Like most workshops, mine is well-populated with spring clamps, the ubiquitous tool for applying localized pressure with one hand while [...]

To support a large panel while I drilled holes in the edge for dowels, I added a second sliding clamp jaw to a pipe clamp and clamped it to the edge of my workbench. -Steve Keller

Spring clamps are easily converted to miter clamps by adding swivel jaws. Remove the vinyl tips, and then hacksaw a 1/2″ long slot down the center of the metal jaws. Use needle-nose [...]

Most of the clamps in our woodworking arsenal are designed to produce tons of pressure per square inch. While we use them to hold pieces over the workbench, close joints, or keep glued parts from [...]

A well-equipped shop will have a variety of clamps for different situations. Here’s our favorites. I think that you’ve probably heard the saying that “a woodworker can never have too many [...]

This light-duty clamp is ideal for small parts-and easy to make by the dozen. All you need are a couple wood scraps, a rubber band, and a short piece of dowel rod. You can vary the pressure by [...]

Tool: Sure-Foot F-Style Clamp Shop Now Manufacturer: Rockler MSRP: $19.99+ There are few tools that couldn’t use an improvement or two—even the humble bar clamp. Rockler thought of a few [...]

I’ve dried my own lumber for years, but I always had a problem getting enough weight on top of the stack, to keep the upper boards from warping. Here’s a solution: Use clamps made from threaded [...]